Ideco T-1000 Triplex Mud Pump
- 6-1/2" x 10" liners with FSFE
- Fluid End Rebuilt, anything needing replaced is
replaced (not all fluid end parts needed replaced yet,
so supplying with Complete Set of new fluid end spares
(expendables) for T-1000 mud pump) 3 months limited warranty.
- Powered by Caterpillar 3508 diesel engine, 3 months limited warranty.
- Certified Good Used PTO Clutch with set of spares, 3 months limited warranty.
- Gears Good
- HYDRIL K-20-5000 Pulsation Dampener
- Skid Mounted
- Completed unit tested to ensure all in good working order, cleaned,
and new paint applied to appear as new.
T-1000 Triplex Pump :
The T-1000 is 12'-5 3/8 " (3,794 mm) in length and weighs 38,400 ibs.
(17,400kg). It has a maximum working pressure of 5,335 psi (36,812 kPa)
and a maximum hp of 1,000 (746 kw) at 140 spm
Frame Design :
The Ideco frame is rigidly fabricated from extra-thick steel plates and
reinforced at points of greatest stress to maintain alignment of the pump's
moving parts. The frame has double wall construction in the area of the
pinion bearings and main bearings for greater rigidity. The crosshead area is
reinforced with two steel bulkheads
Crankshaft :
Ideco's crankcentric crackshaft is forged from alloy steel shaft for extra
strength. The straight-roller, eccentric bearings have positive-splash
lubrication, while the spherical roller main bearings are pressure lubricated
Pinion Shaft :
The shaft assembly is mounted on straight-roller, pressure-lubricated
bearings to facilitate proper meshing of the double-helical gear set.The
double-extended shaft feature allows maximum flexibility in unitizing
the pump to the prime mover.
Crosshead :
The crossheads are made of high strength alloyed ductile iron and replaceable
crossheads guides made of nodular iron and replaceable crosshead guides made
of nodular iron providing long life to wearing surfaces. It is lubricated by a
controlleed-flow system passing through the inner-race wristpin and into the bearing
Fluid End Design :
The fluid end consists of three inter-changeable forgings with valve-over-valve
construction. Cylinder head and valve-pot covers are screwed into replaceable
thread rings. The suction connections are located one in center and one on
either side of the pump.
Price & terms : Please enquire using the email form below.
If you cannot find the vessel, crane, rig or equipment that you need,
please send us an email to mail@worldoils.com stating your
requirements and we shall find it for you.
We can arrange delivery of equipment and towage of rigs and vessels where needed.
The details mentioned above are believed to be accurate but are not guaranteed.
--------------------------------------------------------------------------------------------------------
Triplex Mud Pump for Sale
T-1000 Mud pump for Sale
Triplex Mud Pump 6-1/2" x 10" liners with FSFE
Ideco T-1000Triplex Mud Pump for Sale
--------------------------------------------------------------------------------------------------------
.jpg)
.gif)
and we shall offer you.